Sunydeal replies: The first step is to buy a wall mount rated to hold your TV, so you'll need to know your set's weight and screen size. Then choose a mount type. Fixed, non-adjustable mounts hold a set tight against the wall but limit how high the TV can go. (The screen should be at eye level when you're seated.) With a tilt-swivel mount like the Sunydeal TV mount installed here, the TV sits farther off the wall but rotates side to side up to 90 degrees and tilts up to 15 degrees. That allows you to put the screen higher on the wall than a fixed mount and still enjoy comfortable viewing.
Building codes don't permit TV power cords to be buried in the wall, so you'll want to use a system. This two-piece receptacle kit comes wired to safely hide the cord and A/V cables behind the drywall and pick them up at the base of the wall near your signal and power source. For an even neater installation, run the cables through the hollow arms of the mount.
Step 1：
Mark The Studs
 |
| Mark The Studs |
Find and mark a stud where you want the TV mounted. Measure to the left or right 16 inches and mark the center of the next stud. Using the template that comes with your mount—make sure the template is level—mark the position of four lag screws over two studs.
Step 2：
Install The Wall Mount
 |
| Install The Wall Mount |
Drill pilot holes for the lag screws. Hold the mount up to the wall and position it over the holes. Install the lag bolts and washers with a socket wrench, but don't tighten them completely. Slide the mount left or right depending on where you want the TV, check for level, then tighten each screw, as shown.
Step 3：
Cut The Receptacle Hole
 |
| Cut The Receptacle Hole |
Determine the least-visible spot for the receptacle box, then use a stud finder to make sure that you have a clear shot to the bottom of the stud bay. Place the receptacle template in this spot and trace around it. Use a drywall saw to cut out the wallboard along the template's outline.
Step 4：
Connect The Power
 |
| Connect The Power |
Locate the lower receptacle box within
6 feet of an outlet and repeat Step 3. Insert the upper box and snake the power cord down the wall. Use a screwdriver to twist the wall plate's tabs, locking them behind the drywall. At the lower hole, plug the male end of the power cord into the female end of the lower receptacle.
Step 5：
Insert The Cables
 |
| Insert The Cables |
Back at the upper receptacle, fish the HDMI cable and any other cables through the box's rubber gasket. Leave enough slack to reach the TV at it's maximum extension and then some. Pull the cables through the hole near the base of the wall and through the lower receptacle's rubber gasket. Then attach the wall plate to the drywall, as in Step 4
Step 6：
Mount The TV
 |
| Mount The TV |
Fasten the unattached half of the mount to the back of the TV. Have someone help you lift the TV and hold it steady while you bolt the two halves together. Tighten the nuts with a socket wrench. Plug the TV's power cord into the upper receptacle, then use the supplied extension cord to run power from an outlet to the bottom receptacle.
Follow us on Facebook and provide coupon code to save money.
No comments:
Post a Comment